|
- Tape Kit (T 100)
Five (5) 2" x 6" tape strips. Designed to eliminate
vibration and rattles caused by wire harnesses and
cables. HushMat Quiet Tape secures the wire or cables to
the surface. Simply peel and stick, bridging over the
wire or cable. Also eliminates unnecessary wear of wire
and cable due to excessive vibration. Another unique
solution from HushMat.
-Shop Roll (T 200)
One (1) 1” x 30 Foot shop roll. Great for every
electronic install. If you are installing remote
starters, video, audio or security use the HushMat Quiet
Tape Shop roll. Cuts easily with scissors or box
knife. Simply tack down wires to the back of
headliners, kick panels, instrument panels, door panels,
floor rails and more. Stays adhered to the surface –
guaranteed!
-HushMat Ultra H-2-O Tube
(C 100)
One (1) 1/10th gallon caulk tube of Ultra
H-2-O damping and sealing paste. Great for damping and
sealing hard to reach areas of the automobile. Damp
inside door frames, quarter panels. Seal speaker
enclosures, body panels, mating metal surfaces. Cleans
up easily with water. Ultra H-2-O tubes come with easy
squeeze screw on nozzle. Applies with standard size
caulk gun. Cures in less than 3 hours and retains
flexibility. Paintable and Sandable once cured!
-HushMat Ultra H-2-O Pail
(C 400)
One (1) 5 gallon pail of Ultra H-2-O damping and
sealing paste. You can thin the paste with water and
apply with pneumatic sprayer. Flush sprayer with water
prior to cure. Great for damping and sealing hard to
reach areas of the automobile. Damp inside door
frames, quarter panels. Seal speaker enclosures, body
panels, mating metal surfaces. Ultra H-2-O tubes come
with easy squeeze screw on nozzle. Applies with
standard size caulk gun. Cures in less than 3
hours. Paintable and Sandable once cured!
HushMat Silencer Megabond
High Frequency Sound Absorbing Foam (SIL 1003, SIL 1008
& SIL 1013)
HushMat Silencer Megabond sound absorbing foam is
formulated to withstand the wide range of temperatures
that impact the automobile. Silencer Megabond is a
unique EPDM rubber formula that absorbs high frequency
airborne noise from engine, aftermarket exhaust, wind
that is transmitted through the air.
SIL 1013
– ½” consists of four (4) 12.5 x 23”
sheets of foam. Great for firewall, floor, and trunk
applications. Apply directly on top of HushMat Ultra
damping pads for treatment of sound from 0 – 4000 Hz.
Awesome compression recovery (memory). Outperforms
urethane products by 5X. Awesome for marine and home
application.
SIL 1008
– ¼” consists of two (2) 23” x 36”
sheets of foam. Apply directly on back of door trim
panel, back of headliner or under carpet on floor.
For the ultimate in sound quality apply HushMat Ultra
damping and HushMat Silencer Megabond in your vehicle.
SIL 1003
– 1/8” consists of two (2) 23” x 36”
sheets of foam. Apply directly on back of door trim
panel, kick panels, pillar trim, to eliminate plastic to
metal or plastic to plastic squeaks and rattles. Great
for lining the back of plastic trunk trim. Use SIL
1003 to line trays, console storage and glove boxes to
prevent coins, tools from rattling.
|